Pacific Test Equipment - Test and Measurement Equipments from HP / Agilent Anritsu Tektronix Fluke and etc.

<%-- ************************************************************ HTML Content Started Here ************************************************************ --%>

Mfg. Name	Mfg. Part#	Product	Unit Price	Add To Cart

Agilent / HP	1540-1066	Agilent / HP 1540-1066 Soft Case for 167X Logic Analyzers	$125.00


Agilent / HP	10460A	Agilent / HP 10460A TTL Clock Pod	$145.00
Features Clock output type: 10H125 with 47 Ù series; true and inverted Clock output rate: 100 MHz maximum Clock out delay: 11 ns maximum in 9 steps Clock input type: TTL - 10H124 Clock input rate: dc to 100 MHz Pattern input type: TTL - 10H124 (no connect is logic 1) Clock-in to clock-out: approximately 30 ns Pattern-in to recognition: approximately 15 ns + 1 clk period Recommended lead set: Agilent 10474A

Agilent / HP	10462A	Agilent / HP 10462A 3-State TTL/CMOS Data Pod	$145.00
Features Output typenote 2: 74ACT11244 with 100 Ù series; 10H125 on a non 3-state channel 7 3-State enable: negative true, 100 kÙ to GND, enabled on no connect Maximum clock: 100 MHz Skewnote 1: typical <4 ns; worst case = 12 ns Recommended lead set: Agilent 10474A Note 1: Typical skew measurements made at pod connector with approximately 10 pF/50 kÙ load to GND; worst case skew numbers are a calculation of worst case conditions through circuits. Note 2: Channel 7 on the 3-state pods has been brought out in parallel as a non 3-state signal. By looping this output back into the 3-state enable line, the channel can be used as a 3-stated enable.

Agilent / HP	10483A	Agilent / HP 10483A 3-State 3.3 Volt Pattern Generator Data Pod	$145.00
The 3-State 3.3V data pod supports Agilent Technologies´ 16720A and 1670G-004 pattern generators. Each pattern generator requires at least one clock pod, up to 4 data pods, and lead sets for each clock and data pod. For each 10483A data pod that you will be using, you will need one (1) 10498A lead set. Features Output type: 74AVC16244 3-state enable: negative true; no connect=enabled Maximum clock: 300 MHz Skew: Typical less than 1 ns; worst case 2 ns Recommended lead set: 10498A

Agilent / HP	16534A	Agilent / HP 16534A 500MHz O'Scope Card	$2,850.00
Agilent / HP 16534A 2 Channel, 2 GSa/s Digitizing Oscilloscope 32K depth 2 Channel, 2 GSa/s Digitizing Oscilloscope. 500MHz bandwidth, 8-bit resolution, 32K memory

Agilent / HP	E5346-68701	Agilent / HP E5346 - 68701 MICTOR CONNECTORS SET OF 5	$165.00
The Agilent E5346-68701 Mictor connector provides a convenient and reliable connection to your target. Route your signals of interest to the location containing the Mictor connector and when you are ready to measure these signals simply plug-in the Mictor probe. These probes can be used with a support shroud in environments where accidental unplugging of the probe is a concern. This probe can be used with any Agilent logic analyzer with a 40-pin cable connector. 34 channels, single-ended clock and data Small, 3.0pf, equivalent load capacitance Capable of data rates up to 600Mb/s (maximum rate dependent on analyzer used) 500 mV p-p minimum signal amplitude Small connector is easy to incorporate into your design Agilent number 1252-7431 or AMP number 2-767004-2 Support shrouds available for board thickness to 0.120 inches

Agilent / HP	E5346A	Agilent / HP E5346A Mictor Probe-Single-ended, with 40-pin Cable Connectors	$825.00
The Agilent E5346A Mictor probe provides a convenient and reliable connection to your target through a Mictor connector designed into your target. Route your signals of interest to the location containing the Mictor connector and when you are ready to measure these signals simply plug-in the Mictor probe. These probes can be used with a support shroud in environments where accidental unplugging of the probe is a concern. This probe can be used with any Agilent logic analyzer with a 40-pin cable connector. 34 channels, single-ended clock and data Small, 3.0pf, equivalent load capacitance Capable of data rates up to 600Mb/s (maximum rate dependent on analyzer used) 500 mV p-p minimum signal amplitude Small connector is easy to incorporate into your design Agilent number 1252-7431 or AMP number 2-767004-2 Support shrouds available for board thickness to 0.120 inches

Agilent / HP	E5351A	Agilent / HP E5351A Mictor Probe-Unterminated, with 40-pin Cable Connectors	$625.00
The Agilent E5351A Mictor probe provides a convenient and reliable connection to your target through a Mictor connector designed into your target. Additionally this probe offers the flexibility of designing the probe terminations into your target allowing you to minimize stubs when the connector cannot be placed close to the signals being probed. Route your signals of interest to the location containing the Mictor connector and when you are ready to measure these signals simply plug-in the Mictor probe. These probes can be used with a support shroud in environments where accidental unplugging of the probe is a concern. This probe can be used with any Agilent logic analyzer with a 40-pin cable connector. Features 34 channels, single-ended clock and data Small, 3.0pf, equivalent load capacitance Capable of data rates up to 600Mb/s (maximum rate dependent on analyzer used 500 mV p-p minimum signal amplitude Small connector is easy to incorporate into your design Agilent number 1252-7431 or AMP number 2-767004-2 Support shrouds available for board thickness to 0.120 inches

Tektronix	P6418	Tektronix P6418 17 Channel Logic probe for TLA	$530.00
Frequency Range 200 MHz - 2 GHz Type Logic Analyzer Probe

Tektronix	P6434	Tektronix P6434 Hi Density 34 Channel Probe for TLA	$775.00
Frequency Range 200 MHz - 2 GHz Type Logic Analyzer Probe

reseller, reseller channel development, channel development, reseller development, distribution, distribution management, managment, telemarketing, marketing, marketing surveys, surveys, leads, lead qualification, seminar, seminar recruitment, business development

contact webmaster | powered by corezon

All logos and trademarks are properties of their respective companies. Product price, specification, warranty and availability subject to change without notice.

		Go to Our Web Site
		This is our product index page. Please use this keyword searching to narrow down the result.	Advanced Search